Steps To Mount Frameless Bathroom Mirrors With Glue

Instead of using the J-clips for on smaller, frameless mirrors, you need glue and support to mount large frameless mirrors for bathroom to a wall. To make sure the glue is able to support the mirror attached to the wall, it is important to have the right preparation for wall and mirror. It can cause serious wound by a falling frameless mirror to everyone in the mirror’s surrounding area or cause severe destruction to the neighboring area. Here are the steps to frameless bathroom mirrors installation using glue.

frameless bathroom mirrors discount (1)

Preparation

Use a tape measure to size the height and length of the frameless bathroom mirror. Note on the wall with the mirror’s width and height mark. Use paintbrush to apply the surface of the wall with a coat of primer. Spread 3 inches passing the marks of the mirror with the primer. Let it dry for the time according the manufacturer’s suggestion. The coat of primer should not have light spots.

frameless bathroom mirrors discount (2)

Use fine-grit sandpaper to lightly sand the primed surface of the wall. Use a lint-free cloth to clean the area from the sanding dust. Check the wall for the mirror dimensions. Lengthways the prepared wall, use a stud finder. Put mark at the lowermost height of the mirror for all stud location. On an extent of J-channel, put the mirror width mark. Use a hacksaw to cut the J-channel to the necessary size. Prevent twisting the end of the light-gauge channel by cutting slowly. Line up the J-channel ends with the mirror width marks on the lowermost mirror tallness mark. Make sure the protuberance of the channel is pointed in the direction of the upper height mark for the frameless bathroom mirrors.

frameless bathroom mirrors discount

Applying Glue

Use a battery-operated drill to sink drywall screw at every stud location into the J-channel. Set between 9 and 12 of the clutch if you use a clutched cordless drill. Prepare a tube of mirror glue and insert it in a caulk gun. Spread over the back of the mirror with drops of glue according to the form and proportions suggested by the producer. Ask an assistant to help you lift the mirror. You should not touch the glue smeared to the rear of the mirror. With the glue fronting in the direction of the wall, place into the J-channel the bottom of the mirror. Shove and hold the mirror decisively toward the wall. Hold the mirror in place by tape the ends to the wall. Once the glue has dried completely, take out the masking tape and now you can enjoy your frameless mirrors for bathroom.